| Type of Protection | Ex nA (Non-sparking) Dust protected enclosure |
| Area Classification | Zone 2 and Zone 22 areas |
| ATEX Classification | Group II Category 3 G D |
| ATEX | Type Examination Certificate BAS01ATEX3052X |
| Coding | II 3 G D EEx nA II (refer to table for T rating and Ambient) |
| Enclosure | Marine grade stainless steel body with polycarbonate diffuser and stainless steel retaining clips |
| Reflector/Geartray | White polyester painted zinc coated steel |
| Entry | 3 x 20mm diameter holes, two at one end and one at the other end |
| Termination | 4 core 4mm sq max. conductor with looping and through wiring 16A rating |
| Installation | Two clearance holes for M8 fasteners located on rear of body, sealing washers provided |
| Lampholder | G13 (Bi-pin) |
| Lamp Type | T8 tubular fluorescent |
| Control Gear | High Frequency ballast housed within sealed enclosure, electronic charger/inverter housed in sealed enclosure, Ni-Cd batteries |
| Relamping | Access via front diffuser secured by quick release stainless steel clips |
| Burning Position | Universal |
| Ingress Protection | IP65 to EN 60529 |
| Electrical Supply | 220-240V 50-60Hz |
| Battery | Ni-Cd battery (6V 4Ah) |
| Duration | 3 hours |
| Emergency Output | 36W 10% of one lamp
58W 8% of one lamp |
